Avaya VSP 7000 Technical Configuration Manual page 45

1.6.1.10 VLACP – SPB front ports only
Switch
VLACP - Global
7001, 7002, 7003, 7004
VLACP - Interface
7001, 7002, 7003, 7004

Note that by default, LACP is enabled on the FI rear ports where LACP provides the link integrity
functionality as well as link aggregation.
VLACP - SPB front panel Interface Configuration
Front Ports – Same configuration on 7001, 7002, 7003, and 7004
7001(config)#vlacp macaddress 01:80:c2:00:00:0f
7001(config)#vlacp enable
7001(config)#interface ethernet 3
7001(config-if)#lacp timeout short
7001(config-if)#vlacp timeout-scale 5
7001(config-if)#vlacp enable
7001(config-if)#exit
--------------------------------------------------------------------------------------
7001(config)#show vlacp
=========================================================================
=========================================================================
Multicast address :
Vlacp
Vlacp hold time
--------------------------------------------------------------------------------------
7001(config-if)#show vlacp interface 3
===============================================================================
August 2015
Parameter
VLACP MAC
State
Timers
Time-out-scale
State
Vlacp Global Information
01:80:c2:00:00:0f
: enabled
: 0
VLACP Information
Avaya Inc. – External Distribution
avaya.com
Value
01:80:c2:00:00:0f
enable
Short
5
enable
45