Avaya VSP 7000 Technical Configuration Manual page 42

7004(config)#show lacp port aggr 8223
Port Priority Lacp
---- -------- ------- --- ------- ----- ----- ----- ----- ------- -------
38 32768 Active
39 32768 Active
7004(config)#show lacp port aggr 8224
Port Priority Lacp
---- -------- ------- --- ------- ----- ----- ----- ----- ------- -------
34 32768 Active
35 32768 Active
36 32768 Active
7004(config)#show lacp debug member 34-36,38-39
Port AggrId TrunkId Rx State
---- ------ ------- ------------- ------------- ------------
34 8224 32 Current
35 8224 32 Current
36 8224 32 Current
38 8223 31 Current
39 8223 31 Current

Please note that changing the LACP key on the rear-port interfaces which are already in use as
SPB NNI connections will cause the IS-IS adjacency to bounce.
1.6.1.7 SPB Interface Configuration
SPB Interface Configuration
Rear ports – for this configuration example, we are provisioning only the FI Red (ports 38 & 39) and Black
FI (ports 34, 35, & 36) rear ports. As we are using two LACP keys, we need to select one port from each
LAG and enable SPB. Note if you select all ports, i.e. 34-39, and enable SPBM, this will work, but, you
will simple get an error message stating ISIS is already enabled on port 39, 35, and 36 – simply just
ignore this error message.
Rear Ports – Same configuration on 7001, 7002, 7003, and 7004
7001(config)#interface ethernet 34,38
7001(config-if)#isis
7001(config-if)#isis spbm 1
7001(config-if)#isis enable
7001(config-if)#spanning-tree mstp learning disable
August 2015
Admin Oper
A/I Timeout Key Key
A Short 4095 12287 8223
A Short 4095 12287 8223
Admin Oper
A/I Timeout Key Key
A Short 4094 12286 8224
A Short 4094 12286 8224
A Short 4094 12286 8224
Mux State
Ready
Ready
Ready
Ready
Ready
Avaya Inc. – External Distribution
Trunk Partner
AggId Id Port Status
31 38
31 39
Trunk Partner
AggId Id Port Status
32 34
32 35
32 36
Partner Port
34
35
36
38
39
avaya.com
Active
Active
Active
Active
Active
42