System Setup Menu - Bolin Technology FEX Series User Manual

SYSTEM SETUP Menu

The SYSTEM SETUP menu is used to set the items related to the camera system
FACTORY DEFAULT:
The menu is used to restore the factory settings
DISPLAY CONFIGURATION:
Entered the menu of DISPLAY CONFIGURATION, it will be shown the below items:
ZOOM LENSPOSITION:
Select ON to display the zoom lens position on the screen.
INTERFACE SET:
This menu is used to set the following parameters:
CAMERA ID:
Factory Default Setting: 001
Use RS485 PELCO-D can control up to 255 cameras, camera ID from 001 to
255 must be set.
Use RS422 VISCA protocol can control up to 7 cameras, camera ID from 1 to 7
must be set.
BAUD RATE:
Factory Default Setting: 9600,
Select the baud rate from the following: 2400, 4800, 9600, 38400bps.
NOTE!

After the camera ID and Baud rate are set, to activate the newly configured camera ID and Baud rate, the
camera must be rebooted by powering the camera OFF and ON.

For Dual-Output cameras, the camera ID and Baud rate on IP web interface must be set to the same ID as
the camera's SDI OSD for IP control. (See user manual Part Two)

You may need to reboot the keyboard after you change the camera ID and Baud rate.

Once modified and saved the camera ID and baud rate, please modify the corresponding parameters on
both the keyboard as well as the camera's IP web interface setting, otherwise the camera and keyboard and
IP control will be unable to communicate.
FLIP:
Select ON to flip the image if you need to lift the camera.
33
>EXPOSURE
>WHITE BALANCE
>PICTURE
>LENS PARAMETERS
>SYSTEM SETUP
>FUNCTION SETTING
>SAVE AND EXIT
>EXIT
>ZOOM LENS POSITION: OFF
>EXIT
>FACTORY DEFAULT
>DISPLAY CONFIGURATION
>INTERFACE SET
>FLIP: OFF
>SDI VIDEO: 1080P30
>IP VIDEO: 1080P
>VIDEO FORMAT: 1080P30
>PROPORTIONAL PT: ON
>SET NORTH
>SYSTEM INFO
>SYSTEM RESET
>EXIT
CAMERA ID: 001
BAUD RATE: 9600
FACTORY FORMAT
EXIT