Table of Contents
Advertisement
PRESET SPEED:
Set preset speed value from 0 to 5 to change the preset speed.
PAN DIR:
Camera horizontal Left and right orientation setting, option: Normal/Invert
TILT DIR:
Camera tilt up and down orientation setting, option: Normal/Invert
SYSTEM Menu
PELCO ID
When using RS485 (PELCO P/D) control, Set Camera ID to the address that you want to control to. This value is from
001-255.
IR-RECEIVE (Infrared Signal Reception)
When this is set to OFF, the camera does not receive the
signal from the infrared remote controller.
Be sure to keep it set to ON when you use the infrared
remote controller.
Note
You cannot set IR-RECEIVE to OFF when you operate
the menu using the infrared remote controller. To set it to
OFF, use the appropriate VISCA controller.
DISPLAY INFO
When this item is set to ON, the message of the camera configuration appears for about 3 seconds on the
screen, after the camera is powered on or rebooted.
PRESET MEMORY:
This feature allows you to save the image parameter to PRESET memory, turn it on to save most image
parameters like as picture, white balance, exposure, focus mode, zoom positions when you call the preset.
FACTORY RESET
You can select this item to set camera back to Factory Default setting by pressing HOME button to confirm the action.
All data of the camera that have been set will be deleted.
RELOAD PRESET 1:
When this item is set to ON, preset 1 is set to Home position. The camera goes to Home position when it is powered on
or reset.
VIDEO FMT:
You can change the video format(SDI/HDMI) by adjusting this item. Select the item, press "←" button to choose the
video format you want to set to, then press "→" (Pressing "→" button changes value on some product models) or HOME
button to confirm it. After you confirm your choice, press HOME button again to restore it. The camera will reboot by
itself. The new video format is activated.
You can cancel it by pressing the DATA SCREEN button.
Depending on the video client software you are using, some video software may need to be restarted to obtain the new
video format.
The SDI/HDMI video formats that you can select from are: 1080P:60/59.94/50/30/29.97/25, 1080I:60/59.94/50,
720P:60/59.94/50/30/25
SV:
Software Version Number that is currently running on the camera, you may need this information for technical support.
Note
The camera video format can be changed by setting bottom DIP switch as well.
OSD
EXPOSURE
WHITE BALANCE
>PICTURE
PAN TILT ZOOM
>SYSTEM
29
SYSTEM MENU
PELCO ID
001
IR-RECEIVE
ON
DISPLAY INFO
ON
PRESET MEMORY
ON
FACTORY RESET
RELOAD PRESET 1
ON
VIDEO FMT:
1080P29.97
SV: V0B1100S36040AD04
Advertisement
Table of Contents
