Table of Contents
Advertisement
PICTURE Menu
The PICTURE menu is used to set the items related to the picture.
SHARPNESS:
Picture sharpness value ranges from 0 to 15. You can enjoy emphasized edge and
high-resolution images.
EFFECT: (Picture Effect)
It consists of the following functions:
Image effect from Off, B&W.
NOISE REDUCTION:
Noise reduction - you can enjoy clearer images by removing unnecessary noise.
You can select 6 levels from OFF (MIN), 1 to 5 (MAX).
FLIP:
Image E-Flipper – Used when ceiling mounting or upright mounting. Set to OFF is upright mode, set to ON is for ceiling
mount.
MIRROR: You can use it to horizontally flip video.
DE-FLICKER:
You can turn it ON if the Video output format frame rate is difference from your country's electricity Frequency.
GAMMA:
In this mode, the gamma can be set to value from 0 to 2.
WDR: (Wide dynamic range mode): WDR feature is available on certain product models.
Wide Dynamic: ON, OFF. The camera distinguishes light and dark areas within the same scene, adjusts the
brightness for dark areas, and also controls the blown out highlights.
You can select the wide dynamic range mode between ON and OFF
COLOR
You can configure the color gain. Use this setting when bright color is particularly important.
HUE
You can adjust color phase from 1-15.
Defog mode
When the surrounding area of the subject is foggy and low contrast, the defog mode will make the subject appear
clearer.
PAN TILT ZOOM Menu
The PAN TILT ZOOM menu is used to select the pan/tilt/ zoom mode.
DIGITAL ZOOM:
Set to DIGITAL ZOOM ON, 12X digital zoom is activated.
You can set digital zoom to ON or OFF. When set to OFF, digital zoom does not operate,
and only optical zoom is available. When set to ON, digital zoom takes over after
optical zoom reaches MAX (10× ). Up to 120× can be zoomed digitally.
When digital zoom is available, the resolution decreases
P/T SPEED:
Set P/T Speed value to from 1 to 5 (The speed from low to high), to change the speed of P/T on remote controller.
ZOOM RATIO OSD (Zoom times display):
Set Ratio OSD to ON, the number of the zoom times that you are operating displays on screen.
SYSTEM Menu
PELCO ID
This Camera ID setting on the menu is only for Pelco camera ID when using RS485 Pelco
protocol.
Set Camera ID to the address that you want to control to. This value is from 001-255.
For VISCA CAMERA ID:
Set the VISCA camera ID on DIP Switch (See page 17).
Use RS422 VISCA protocol can control up to 7 cameras, camera ID from 1 to 7 has
to be set.
After the camera ID and Baud rate is set, to activate the new set camera ID and Baud
rate, the camera has to be rebooted by powering the camera OFF and ON.
21
Advertisement
Table of Contents
