Installing Your Camera; Rj45 Water-Resistant Connector Installation Guide - Bolin Technology FEX Series User Manual

Installing Your Camera

NOTE:

The camera is completely sealed with pressurized nitrogen inside.

Do not open your camera nor release the Nitrogen air from the Schrader Valves without authorization from a BOLIN
Technology Support representative

Opening the camera and / or releasing the nitrogen from inside the it may damage the camera. This will void the
warranty.

The diagrams included in this user guide are for reference only. See the actual product to install and mount your camera.
The pigtail cable is detachable. It includes:
1. RJ45 connector for IP video streaming and POE power
2. RS422/RS485 connector for serial control
3. 12VDC injector for power
4. BNC connector for SDI video signal output
5. Four sets of water-resistant couplers for the connectors
Please follow the instruction below to install the connectors and water-resistant couplers correctly.

RJ45 Water-resistant Connector Installation Guide

The RJ45 connector is IP67 water-resistant rated.
Please follow the illustration bellow to install the
connector.
1. POE-ready Ethernet Port (Built with water
Resistant Coupler)
2. RJ45 Head
3. Ethernet Cable (CAT5e/ CAT6)
4. Silicone Ring
5. Paw
6. Silica Gel Pad
7. Cap
1. Insert the Ethernet cable through the water-
resistant head kit (parts 4, 5, 6 and 7)
2. Terminate the cable to an RJ45 head
3. Insert the RJ45 head into the Ethernet port
4. Tighten the head kits (parts 4, 5, 6 and 7)