System Menu - Bolin Technology UCC-2HD10BT-U32 User Manual

SYSTEM Menu

PELCO ID
When using RS485 (PELCO P/D) control, Set Camera ID to the address that you
want to control to. This value is from 001-255.
IR-RECEIVE (Infrared Signal Reception)
When this is set to OFF, the camera does not receive the signal from the infrared
remote controller.
Be sure to keep it set to ON when you use the infrared remote controller.
Note
You cannot set IR-RECEIVE to OFF when you operate the menu using the infrared remote controller. To set it to OFF,
use the appropriate VISCA controller.
DISPLAY INFO
When this item is set to ON, the message of the camera configuration appears for about 3 seconds on the
screen, after the camera is powered on or rebooted.
PRESET MEMORY:
This feature allows you to save the image parameter to PRESET memory, turn it on to save most image
parameters such as picture, white balance, exposure, focus mode, zoom positions when you call the preset.
FACTORY RESET
You can select this item to set camera back to Factory Default setting by pressing HOME button to confirm the action.
All data of the camera that have been set will be deleted.
RELOAD PRESET 1:
When this item is set to ON. The camera goes to Home position when it is powered on or reset, it allows you
to save the image parameter to preset, such as picture, white balance, exposure, focus mode, zoom positions.
AUTO FOCUS
Set speed of auto-focusing from Low to Normal.
HDMI FORMAT:
You can change the video format by adjusting this item. Select the item, press "←" and "→" button to choose
the video format you want to set to, then press "Home" (Pressing "→" button changes value on some product
models) or HOME button to confirm it. After you confirm your choice, press HOME button again to restore it.
The camera will reboot by itself. The new video format is activated.
You can cancel it by pressing the MENU button.
Depending on the video client software you are using, some video software may need to be restarted to obtain
the new video format.
The video formats that you can select from are: 720P50, 1080P25, 1080P60, 720P60, 1080P30, 1080P50.
You can set HDMI video format separately from the USB3.0/2.0 video format. The HDMI does not have to be
the same format as USB3.0/2.0's.
Note
The camera video format can be changed by setting bottom DIP switch as well.
23