AWG
Stranding
18
Solid
Shield Material
Type
Layer
Tape
1
Braid
2
Nom. Capacitance Conductor to shield
16.2 pF/ft
Install the Tail Cable
Install and detach the Tail Cable included with the product as following:
1. Hold the MS female connector head and pull back the ring of the connector.
2. Insert the MS female connector head into the MS male connector on the camera completely until you hear the lock
sound when the connection is in place and release the ring.
Mounting the Camera
Check Camera Components and Installation Conditions Before mounting your camera, check the device model number and
included contents against the packing list to ensure components are complete.
Important:
1. Verify the bearing capacity of the surface where the camera will be mounted
Material
Nominal Diameter
Bare Copper
0.04 in.
Material
Aluminum / Polyester / Aluminum 100%
Tinned Copper
Nom. Inductance
0.106 µ H/ft
Coverage
95%
Nom. Char. Impedance
75 Ohm