Power; Cable Requirements - Bolin Technology VCC-7 Series User Manual

Power

•
Use only the DC power adaptor (JEITA type4) supplied with the unit. Do not use any
other DC power adaptor.
•
If using POE to power the camera, PoE+(IEEE802.3bt) is supported
•
Ensure that the POE power source has sufficient power budget to power the camera, or some features may not
function properly.
•
You can use One-Cable POH (Power Over HDBaseT) power up the camera via CAT6 cable when
HDBaseT video card is used.

Cable Requirements

•
Network Cable: 10/100 Mbps Ethernet CAT 5/5E/6 UTP cables are applicable to the ANSI/EIA/TIA-568A/B
and ISO/D. Eight wires in the network cable need to be inserted in parallel into the top of the cable connector.
The cable connector needs to be crimped in position. When the cable connector is in position, ensure that the
metal pieces of the cable connector are parallel to each other and the clamp of the cable connector is intact.
•
SDI Cable: For broadcast use, Belden1694A/5CFB is a suitable cable to transmit broadcast-quality video:
Conductor:
AWG Stranding
18 Solid
Shield Material
Type Layer
Tape 1
Braid 2
Nom. Capacitance
Conductor to shield
16.2 pF/ft
Material Nominal Diameter
Bare Copper 0.04 in.
Material
Aluminum / Polyester / Aluminum
Tinned Copper
Nom. Inductance
0.106 µ H/ft
Coverage
100%
95%
Nom. Char. Impedance
75 Ohm
13