Install The Tail Cable; Mounting The Camera; Power The Camera - Bolin Technology FEX30BHD-RNP2 User Manual

Cable Requirements
Network Cable 10/100 Mbps Ethernet CAT 5/5E/6 UTP cables are applicable to the ANSI/EIA/TIA-568A/B and ISO/D.
Eight wires in the network cable need to be inserted in parallel into the top of the cable connector. The cable connector needs
to be crimped in position. When the cable connector is in position, ensure that the metal pieces of the cable connector are
parallel to each other and the clamp of the cable connector is intact.

Install the Tail Cable

Install and detach the Tail Cable included with the product as
following:

Mounting the Camera

Check Camera Components and Installation Conditions Before
mounting your camera, check the device model number and included
contents against the packing list to ensure components are complete.
Important:
1. Verify the bearing capacity of the mounted position
2. Verify that the mounted position meets the bearing requirements. Otherwise, you are advised to reinforce the mounted
position for the device weight. For more information, see the product datasheet.
3. Verify lightning protection and grounding requirements
4. Ground the terminal properly.
NOTE:

When mounting the camera, please install the bracket adapter to the bracket first and
then mount the camera to the racket.

Tighten all the screws to hold the camera securely.

Power the camera

NOTE:

Do not turn on the power nor connect the power/POE network cable to the camera Tail Cable until the camera Tail Cable
has been connected completely to the camera.
Use IEEE802.3at standard POE power adaptor or POE switch to power the camera. It takes about 2 minutes for the camera to
be completely powered on.
11