Siemens SINUMERIK 840D sl Operating Manual page 116

Machine the workpiece
3.11 Display G and auxiliary functions
Group
G group 1
G group 2
G group 3
G group 6
G group 7
G group 8
G group 9
G group 10
G group 13
G group 14
G group 15
G group 16
G group 21
G group 22
G group 29
G group 30
Procedure
...
The G groups selection displayed in the "G Functions" window may differ.
116
Meaning
Modally active motion commands (e.g. G0, G1, G2, G3)
Non-modally active motion commands, dwell time (e.g. G4, G74, G75)
Programmable offsets, working area limitations and pole programming (e.g.
TRANS, ROT, G25, G110)
Plane selection (e.g. G17, G18)
Tool radius compensation (e.g. G40, G42)
Settable work offset (e.g. G54, G57, G500)
Offset suppression (e.g. SUPA, G53)
Exact stop - continuous-path mode (e.g. G60, G641)
Workpiece dimensioning inches/metric (e.g. G70, G700)
Workpiece dimensioning absolute/incremental (G90)
Feedrate type (e.g. G93, G961, G972)
Feedrate override on inside and outside curvature (e.g. CFC)
Acceleration profile (e.g. SOFT, DRIVE)
Tool offset types (e.g. CUT2D, CUT2DF)
Radius/diameter programming (e.g. DIAMOF, DIAMCYCOF)
Compressor ON/OFF (e.g. COMPOF)
1. Select the "Machine" operating area.
2. Press the "JOG", "AUTO", or "MDA" key.
3. Press the "G functions" softkey.
The "G Functions" window is opened.
4. Press the "G functions" softkey again to hide the window again.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Operating Manual, 01/2008, 6FC5398-6AP10-2BA0
HMI sl Universal