Selecting A Magazine - Siemens SINUMERIK 840D sl Operating Manual

Tool management
6.5 Tool list
6.5.5

Selecting a magazine

You can directly select the buffer memory, the magazine, or the NC memory.
Procedure
Hiding magazines
164
1. Select the "Parameter" operating area.
2. Press the "Tool list" softkey.
3. Press the "Magazine selection" softkey.
If there is only one magazine, you will move from one area to the next
(i.e. from the buffer memory to the magazine, from the magazine to
the NC memory, and from the NC memory back to the buffer memory)
each time you press the softkey. The cursor is positioned at the
beginning of the magazine each time.
- OR -
If there is more than one magazine, the "Magazine Selection" window
opens. Position the cursor on the desired magazine in this window
and press the "Go to" softkey.
The cursor jumps directly to the beginning of the specified magazine.
Operating Manual, 01/2008, 6FC5398-6AP10-2BA0
HMI sl Universal