Executing An Mda Program - Siemens SINUMERIK 840D sl Operating Manual

Setting up the machine
2.9 MDA
2.9.3

Executing an MDA program

Proceed as follows
When executing the G-code commands, you can control the sequence as follows:
● Executing the program block-by-block
● Testing the program
● Setting the test-run feedrate
See also
Program control (Page 90)
72
1. Select the "Machine" operating area.
2. Press the "MDA" key.
The MDA editor opens.
3. Input the desired G-code commands using the operator's keyboard.
4. Press the "CYCLE START" key.
The control executes the input blocks.
Settings under program control
Settings under program control
Operating Manual, 01/2008, 6FC5398-6AP10-2BA0
HMI sl Universal