Lubrication And Fluids Chart; Hazardous Waste Disposal - Taylor-Dunn TT-316-36 Service And Replacement Parts Manual

Lubrication & PM

LUBRICATION AND FLUIDS CHART

Assembly Component
Front Axle/Steering:
1: Fork Pivot
3: Wheel Bearing
Fork Collar Bearings
Steering Box Chains
Brake Fluid:
Master Cylinder
Linkages:
2: Brake Pedal Pivot
Misc
Rear Transaxle:
4: Level/Fill Plug,(GT Axle) 1
5: Drain Plug
9: Fill Plug (SD Axle)
10: Motor Coupler
11:Fill/Level (SD Axle)

HAZARDOUS WASTE DISPOSAL

This vehicle contains various components and/or fluids that may be classified as hazardous waste.
This includes but is not limited to Lead, Acid, Oil, Grease.
The brake linings originally installed by the factory do not contain asbestos. However, since it is possible that
asbestos brake linings were installed as replacement parts, brake linings should be handled as hazardous
waste.
The requirements for disposal of hazardous waste vary by location. Consult your local regulations regarding
the proper disposal of hazardous waste products.
Page 22
# Capacity Lubricant
2 - NLGI Grade 2 lithium multi-purpose grease
2 - NLGI Grade 2 lithium high temp Bearing Grease
2 - NLGI Grade 2 lithium multi-purpose grease
2 - High quality motorcycle chain lubricant
1 - DOT 3, Meets or exceeds SAE J1703
2 NLGI Grade 2 lithium multi-purpose grease
- Multi-purpose spray lubricant
1.4-1.9 Liters SAE 80W90 Gear Oil
1 -
1 1.4 Liters SAE 80W90 Gear Oil
1 Part # 94-421-34 Moly Paste Grease
1 0.75 Liters SAE 80W90 Gear Oil
TT-316-36
MT-316-06