Taylor-Dunn TT-316-36 Service And Replacement Parts Manual page 25

TT-316-36
First 25 hours of Operation
Re-torque wheel nuts.
Inspect all hardware for tightness.
Adjust front wheel bearings.
Every Week
All daily items plus the following:
Check all tires, inflation
Check all tires, damage
Check all tires tread for debris.
Battery electrolyte level
Every Month or 100 hours
All weekly items plus the following:
Fluid leaks
Brake master cylinder fluid level
Clean batteries and terminals.
Tighten steering shaft couplers and/or U-joints.
Inspect all electrical interlocks for proper operation.
Clean exterior of drive motor.
Check tire tread wear.
Check front fork collar bearings for play
Inspect and tighten all hardware (1st 100 hours then
every 500 hours).
MT-316-06
Lubrication & PM
Every 3 Months or 500 hours
All monthly items plus the following:
Inspect and tighten all hardware.
Test batteries.
Clean battery compartment.
Clean motor control panel.
Adjust park and/or service brake.
Re-torque the wheel nuts.
Clean and lubricate motor coupler.
Adjust steering reduction box chains.
Lubricate the vehicle.
Inspect and tighten all power electrical connections.
Inspect all wiring for cracks, fraying, or wear.
Blow carbon from motor.
Inspect motor brushes and commutator.
Inspect and adjust front wheel bearings.
Every 6 Months or 1,000 hours)
All 3 month items plus the following:
Inspect rear wheel bearings.
Inspect suspension bushings and bumpers.
Rotate tires.
Inspect frame for damage.
Every Year or 2,000 hours
All 6 month items plus the following:
Change rear axle oil.
Flush hydraulic brake system.
Clean and repack front wheel bearings, change
seals.
Inspect brakes for wear.
Page 25