Lubrication; Lubrication And Fluids Chart; Hazardous Waste Disposal - Taylor-Dunn BIGFOOT B5-440-36 Operation, T Roubleshooting And Replacement Parts Manual

Lubrication

LUBRICATION AND FLUIDS CHART

Assembly Component
Front Axle:
3: Wheel Bearings
> Refer to procedure later in this section
4: King Pin
Suspension:
5: Rear spring eyes
Steering:
1: Steering Rack
2: 90° Steering Gear
6: Collapsible steering shaft 1
Brake Fluid:
Master Cylinder
Linkages:
Park brake handle
Rear Transaxle:
7: Drain Plug (ref)
8: Level Plug (ref)
9: Fill Plug
10: Motor Coupler

HAZARDOUS WASTE DISPOSAL

This vehicle contains various components and/or fluids that may be classified as hazardous waste.
This includes but is not limited to Lead, Acid, Oil, Grease.
The brake linings originally installed by the factory do not contain asbestos. However, since it is possible that asbestos
brake linings were installed as replacement parts, brake linings should be handled as hazardous waste.
The requirements for disposal of hazardous waste vary by location. Consult your local regulations regarding the
proper disposal of hazardous waste products.
Page 22
# of Locations Capacity
2 -
4 -
6
1
1
1
1 -
1 1.4-1.9 Liters
1
Lubricant
NLGI Grade 2 lithium high temp Bearing Grease
NLGI Grade 2 lithium multi-purpose grease
NLGI Grade 2 lithium multi-purpose grease
NLGI Grade 2 lithium multi-purpose grease
NLGI Grade 2 lithium multi-purpose grease
NLGI Grade 2 lithium multi-purpose grease
DOT 3, Meets or exceeds SAE J1703
Multi-purpose spray lubricant
SAE 80W90 Gear Oil
Part # 94-421-34 Moly Paste Grease
B5-440-36 / B5-440-48
MB-440-01