Multiple Mounting - Epson G3 Series Manual

Setup & Operation 3. Environments and Installation
(2) Using nippers, cut off the wire tie
(3) Remove the bolts securing the wire ties
(4) Remove the fixing jig for transport.

3.5.2 Multiple Mounting

■ Install the Multiple Mounting Manipulator with two or more people.
The Manipulator weights are as follows. Be careful not to get hands, fingers, or
feet caught and/or have equipment damaged by a fall of the Manipulator.
G3-301*M : approx. 14 kg: 31 lb.
G3-351*M : approx. 14 kg: 31 lb.
WARNING
■ When installing the Manipulator to the wall, support the Manipulator, and then
secure the anchor bolts. Removing the support without securing the anchor
bolts properly is extremely hazardous and may result in fall of the Manipulator.
NOTE
Design and make the base table for anchoring the Multiple Mounting Manipulators so that

it does not touch any cable connected to the base connector plate and duct.
The recommended installation patterns are as follows:
44
binding the shaft and arm retaining
bracket on the base.
removed in step (2).
Side
Wire tie
Ceiling
Bolt
:M4×15
Sheet
G3 Rev.14