Table of Contents
Advertisement
Function Keys
In general, each key has two functions. One is marked on the key, and is enabled
via a short press. The second function is marked under the key, and is enabled by a
long (>2 seconds) press.
Selects the
Toggles backlighting ON and OFF.
HOLD
Freezes/unfreezes the displayed measurement on the LCD.
SET-UP
Accesses the instrument's setup parameters and information.
Applies lead compensation for use in continuity testing.
Activates/deactivates alarms.
The and ► keys allow you to:
•
and ►
•
•
Sets the present measurement as a "zero reference" to which future
∆
Rel
measurements are compared.
MEM
Records measurements.
CLR
Erase recorded measurements.
Enable Bluetooth wireless communication.
Installing Batteries
1.
Disconnect any attached leads or accessories from the instrument and turn the
rotary switch to OFF.
2.
Use a tool or a coin to turn the quarter-turn screw of the battery compartment
cover.
3.
Remove the battery compartment cover.
4.
Remove the batteries from the compartment.
5.
Place the new batteries in the compartment, ensuring that each battery's polar-
ity is correct.
6.
Put the battery cover in place and screw the quarter-turn screw back in.
Installing DataView
1.
Insert the DataView thumb drive into an available USB port (wait for driver to be
installed).
2.
If Autorun is enabled, an AutoPlay window appears on your screen. Click "Open
folder to view files" to display the DataView folder. If Autorun is not enabled or
allowed, use Windows Explorer to locate and open the USB drive labeled "Data-
View."
,
, PI, and DAR functions.
Select the displayed information and program the durations of
insulation measurements.
Choose the continuity test current.
Program the alarm thresholds.
®
Advertisement
Table of Contents
