Table of Contents
Advertisement
Then choose from:
Trace Display States
In SA Mode you can display up to four of the following types of trace states. All
SA settings are applied to all displayed traces.
A color-coded legend for displayed traces is visible in the left pane of the SA
mode screen:
W = Clear/Write; M = MaxHold; m = MinHold; A = Average; V = View
How to display Trace States
Press Trace 6.
Then
Then
Then choose from the following Trace States:
Press
NOTE
Trace 4 data WILL be overwritten by the FieldFox when using the Independent
Source Normalize feature (page 86) or using Field Strength antenna or cable
corrections (page 83).
Average Type
In SA Mode, there are four different processes in which Averaging is performed:
Average Traces – Learn more on page 99.
Detection Method Averaging – Learn more on page 101.
Noise Marker Averaging - Learn more on page 103.
Video BW filtering (for non-Zero Span measurements) - Learn more on page
SA (Spectrum Analyzer) Mode
101 | 201 | 401 | 601 | 801 | 1001
Trace 1,2,3,4
repeatedly to select a trace number to display. Traces are
displayed in the following colors:
Trace 1 – Yellow
o
Trace 3 – Orange
o
State [current setting]
Clr /Wr
(Clear/Write) Displays the actual measured data for each sweep.
o
MaxHold
Displays the maximum response of the input signal at each data
o
point over multiple sweeps. See also Average Count on page 100.
MinHold
Displays the minimum response of the input signal at each data
o
point over multiple sweeps. See also Average Count on page 100.
Average
Each data point is averaged over multiple sweeps as set by the
o
Average Count setting. Learn more in following Average Type section.
View
Displays and then holds the last complete measurement trace on the
o
screen. This is similar to storing a trace in memory.
Blank
Displays no trace.
o
Default All
to return all traces to their default settings: Trace 1
(Clear/Write); all other traces (Blank).
90.
Trace 2 – Blue
Trace 4 – Red
.
99
Advertisement
Chapters
Table of Contents
