Trace 1 - Corrected trace with antenna factor. (Antenna = ON, Apply Corr = ON)
Trace 2
Red Trace
Learn how to set Y-Axis Units on page 80.
Use a Band Power marker to measure total power over a range of frequencies.
How to select correction for Field Strength measurements
The Antenna and Cable correction data survives a Mode Preset and Preset.
All Correction ON/OFF states survive a Mode Preset, but NOT a Preset.
Press Scale/Amptd .
Then
Then
Then choose from the following:
Using the Antenna/Cable Editor
The Antenna Editor and the Cable Editor menus are very similar. Both tables
include header information, and a Frequency/Value table.
FieldFox Antenna Editor
84
- (View) Uncorrected trace (Apply Corr = OFF)
- Current correction factor. See below.
Learn how on page 158.
More
Corrections
Apply Corrections ON OFF
o
Antenna ON OFF
Turn ON and OFF Antenna correction.
o
Edit/Save/Recall Antennas
o
below.
Cable ON OFF
Turn ON and OFF Cable correction.
o
Edit/Save/Recall Cables
o
View Corrections ON OFF
o
corrections.
Turn ON and OFF correction for all settings
Recall or edit an Antenna Correction table. See
Recall or edit a Cable Correction table. See below.
Turn ON and OFF
Red Trace
- Antenna/Cable
FieldFox User's Guide