Agilent Technologies FieldFox N9913A User Manual page 52

The following settings will increase the dynamic range of your NA mode
measurement.
 Increase Power Level: Press Meas 4 then Output Power High
 Lower the IFBW: Press BW 2 then IF BW
 Increase Averaging: Press BW 2 then Average
The following procedure MAY increase the dynamic range of your NA mode
measurement. The results you see will depend on the performance of your DUT.
With an S21 trace active:
1. With RF OUT (port-2) open, press Trace 6 then Math and Memory
then
Data->Mem
2. Re-connect the DUT.
Data Math Data-Mem
3. Press then
52 FieldFox User's Guide