Agilent Technologies FieldFox N9913A User Manual page 41

An x3H configuration. Tr2 is the ACTIVE trace as indicated by the highlighted
Trace Setting Notes
 The Frequency Range, IF BW, Resolution, Average, and Output Power settings
 All other trace settings, such as measurement, format, and limit lines, are
 By default, a marker is created on ALL traces as shown in the above image.
How to select a multi-trace configuration
 Press Trace 6
 Then
 Then choose from the following:
NA (Network Analyzer) Mode
are common for all displayed traces.
applied individually to the ACTIVE trace in the same manner as when a single
trace is present.
However, they can be created individually by disabling Coupled Markers.
Learn more on page 151.
Num Traces
The default measurements depend on the options that are installed.
x1
1 trace standard configuration
x2
2 traces overlayed on a single graticule
x2H
2 traces on separate horizontal graticules
x3H
3 traces on separate horizontal graticules
X3
3 traces overlayed on a single graticule
x4
4 traces on separate graticules
Tr 2
41