Channel Selection - Agilent Technologies FieldFox N9913A User Manual

How to Import and Delete a Custom Radio Standard
First, press Save/Recall and select the
will be read. Most likely this will be USB or SD Card.
 Press Measure 1 OR Freq/Dist then
 Then
 Then
 Then select the *.csv file using the ▲|▼ arrows or rotary knob and press
 Custom Radio Standards can be removed from the FieldFox by selecting
 Then select the *.csv file to delete using the ▲|▼ arrows or rotary knob and
NOTE To overwrite a custom standard that is already uploaded to the FieldFox, you
must first delete the *.csv file from the FieldFox, then re-upload the file that
contains the standard. A predefined internal standard (such as GSM 450) can
NOT be deleted from the FieldFox.

Channel Selection

After a Radio Standard has been selected, the frequency range can be changed by
selecting channel numbers rather than frequency. Once enabled, the channel
number is appended to the X-axis frequency range.
How to enable Channel selection
 Press Freq/Dist
 Then
 Then
How to change the Channel Number of the measurement
With Unit =
the selected Radio Standard.
 Press Freq/Dist
 Then choose from the following:
SA (Spectrum Analyzer) Mode
Radio Standard
Import Radio Standards
Enter.
Measure 1 then Radio Standard
press Enter.
More
Unit Freq Chan
Chan
the FieldFox will NOT allow you to specify channels outside of
Center Channel
Places the center frequency of the specified channel in the
o
middle of the X-axis.
Start Channel
Places the lowest frequency of the specified channel at the
o
beginning of the X-axis.
Stop Channel
Places the highest frequency of the specified channel at the
o
end of the X-axis.
Freq Span
Changes the span of frequencies while the center frequency
o
remains unchanged.
Follow each of the above settings by entering a value using the numeric
o
keypad or the rotary knob.
Device
from which the Radio Standard
More
Delete Radio Standard.
then
79