Preset; Volume Control; Display Settings - Agilent Technologies FieldFox N9913A User Manual


 Hold

How to perform a single sweep while in Hold
 Press Sweep 3.
 Then choose one of the following:

Preset

The Preset key restores the FieldFox measurement settings to a known condition.
You can preset the entire instrument, or just the current Mode (CAT, SA, Power
Meter, NA.)
When Preset, the FieldFox performs a calibration for use in CAT and NA Modes.
Learn more on page 63.
The following settings always survive Preset and Mode Preset:
 External Reference state (page 181)
 SA Units (page 80)
 SA Correction states (page 83)
 VVM Display Resolution (page 142)
 Marker Peak Excursion and Threshold (page 156)
 Volume Control
How to Preset the FieldFox
 Press Preset.
 Then choose one of the following:
Audio (Volume) Control
System volume control is a FieldFox global setting which sets speaker volume for
ALL success beeps, key press clicks, and individual features that use the
FieldFox speaker, such as SA Mode Tune and Listen.
The volume control setting remains through a FieldFox Preset. To cause your
volume control setting to remain through a FieldFox shutdown, save the setting
as a Preference. Learn how on page 177.
System Settings
Continuous
Hold
-->
is displayed while a single sweep occurs.
Single
Automatically sets Continuous OFF (Hold) and causes FieldFox to
o
make ONE measurement sweep, then hold for the next Single key press.
SA Mode ONLY – With
o
also causes a single sweep.
Continuous ON OFF
o
when battery power is not critical.
Preset
Returns ALL Modes to the factory default settings.
o
Mode Preset
Returns only the current Mode to the factory default settings.
o
The current settings for all other Modes remain.
Continuous OFF each successive Run/Hold press
Makes continuous sweeps. This is the typical setting
173