Recording Configuration - Agilent Technologies FieldFox N9913A User Manual



Recording Configuration

To change Recording Configuration settings:
 Press Trace 6
 Then
 Then
 Then
Then choose from the following:
Interference Analyzer (SA Mode) Option 236
Playback Trace
Activated automatically when Paused. Allows you to
o
continue playback from a specific trace, or scroll through traces manually.
Enter a value between 1 and the total number of traces using the numeric
keypad, ▲|▼ arrows, or the rotary knob.
Stop
Immediately stops playback. Then choose from the following:
Play
Start playback from trace 1.
o
Record
Resume recording from the last recorded trace.
o
Record Playback Setup
o
settings or Close the session.
Record Playback Setup
New Session Recall
or
Recording Configuration
Record Time
Sets the amount of time to record traces. Default is MAX,
o
which is to record indefinitely. Enter a value between 1s and 1 Ms (million)
seconds using the numeric keypad, ▲|▼ arrows, or the rotary knob. When
set, a timer appears during recording in the lower-left corner which counts
DOWN from the specified time.
Record Source
Sets where, in the FieldFox data flow, data is recorded.
o
Learn more about Record Source on page 124.
Choose from the following:
RawMeas
Records raw measurement data.
o
Trace 1,2,3,4
Records data from the corresponding trace in its current state.
o
Record Interval
Sets the amount of time to wait between individual trace
o
recordings. Default is MIN, which is to wait 0 seconds (record traces as fast
as possible). Enter a value in seconds between 0 (no delay) and 10,000
seconds - about 3 hrs) using the numeric keypad, ▲|▼ arrows, or the rotary
knob.
Segment Count
Sets the number of traces to record, after which the
o
recording will automatically pause. Press Pause/Resume or Record to
capture another N traces, or Stop to end recording. Default is OFF, which is
NO limit to the number of traces to be recorded. When set, a counter appears
in the lower-left corner which counts UP to the specified number of
recordings.
FreqMaskTrigger OFF ON
o
recording. Set these power levels (mask) exactly as you would set Limit
Lines. (Learn how on page 158.) With Record ON, when any data point
measurement is higher than an upper limit, or lower than a lower limit,
recording begins. See Frequency Mask Trigger Configuration in the following
section to learn how to configure the mask.
Return to the setup menu to change Configuration
an existing session.
Sets the power level which will trigger a
123