Agilent Technologies FieldFox N9913A User Manual page 139

How to set Single or Continuous
 Press Sweep 3.
 Then choose one of the following:
You can also use Run / Hold +/- to toggle between Single and Continuous.
Step Detection Mode
The FieldFox supports the Step Detection feature that is present in Agilent USB
power sensors. When enabled, this feature reduces settling time after a
significant step in the measured power. For more information, please refer to the
USB Power Meter documentation.
How to set Step Detection mode
 Press Meas Setup 4.
 Then
 Then choose from the following:
Limits
In Power Meter Mode, Minimum and Maximum limits set a visible range of
acceptable readings between these two values. Readings that are below the
minimum or above the maximum are clearly visible on the power meter display.
How to set Limits
 Press Limit 8.
 Then choose from the following:
Power Meter Mode
Single
Automatically sets Continuous OFF and causes FieldFox to make
o
ONE measurement, then hold for the next Single key press. When a data
trace is displayed, the entire trace is measured, then holds. The
annotation changes to an arrow
Continuous
Makes continuous measurements. This is the typical setting
o
when battery power is not critical.
Step Detection ON Off
ON Enables step detection (default setting)
o
OFF Disables step detection
o
Min Limit On Off
Toggles the display of the Minimum limit ON and OFF.
o
Min Limit Value
Sets the Minimum limit power value. Power reading lower
o
than this will exceed the limit.
Max Limit On Off
Toggles the display of the Maximum limit ON and OFF.
o
Max Limit Value
Sets the Maximum limit power value. Power reading
o
higher than this will exceed the limit.
--> while the measurement occurs.
Hold
139