Agilent Technologies FieldFox N9913A User Manual page 87

Tune & Listen ON with Tune Frequency indicated by a vertical bar (highlighted).
How to select Tune & Listen
 Press Measure 1
 Then
 Then choose a demodulation type. Select a setting based on the type of
Tune Frequency
The Tune & Listen tuner is separate from the SA display. This allows you to
listen to one frequency while displaying a different range of frequencies.
Set the Tune Frequency using one of three methods:
1. Selecting Preset, Mode Preset, or Meas Preset sets Tune Frequency to 3.0 GHz.
2. Specify Tune Frequency:
 Press Meas Setup 4
 Then
 Enter a value using the numeric keypad, ▲|▼ arrows, or the rotary knob.
 3. Using Mkr->Tune Freq
 Create a normal marker at the frequency of interest. Learn how on page 148.
 Press Mkr->/Tools
SA (Spectrum Analyzer) Mode
Tune & Listen
interfering signal you suspect is being broadcast.
None
Turns Tune & Listen OFF
o
AM
Amplitude Modulation
o
FM Narrow
Frequency Modulation; Narrow bandwidth. Choose when
o
interfering transmission consist of voice or data.
FM Wide
Frequency Modulation; Wide bandwidth. Choose for high quality
o
music transmissions of FM broadcast radio.
Tune Freq
Then select a multiplier key. Learn about multiplier abbreviations on page 19.
87