Inspecting The Shipment; Checking The Operation Of Keysight B2900 - Keysight Technologies B2900 Series User Manual

Installation

Inspecting the Shipment

Inspecting the Shipment
Perform the following inspections when the Keysight B2900 and accessories arrive
at your site.
1. Before unpacking any component, inspect all boxes for any signs of damage that
might have occurred during shipment, such as:
• dents
• scratches
• cuts
• water marks
If you suspect any damage, contact your nearest Keysight Sales and Support
Office.
2. When you open the boxes that contain the B2900 and accessories, check the
components against the contents lists attached to the boxes.
If anything is missing, contact your nearest Keysight Sales and Support Office.
3. Verify the operation of B2900 as described in
Keysight B2900".
If any problem occurs, contact your nearest Keysight Sales and Support Office.

Checking the Operation of Keysight B2900

1. Make sure that the standby switch is set to off.
2. Connect the power cord from the B2900's rear panel AC input connector
(receptacle) to an AC power outlet at your site.
3. Press the standby switch to turn on the instrument.
The initialization screen will appear on the B2900's front panel display, and the
power-on self-test is automatically executed.
If the B2900 is operating normally, the front panel LCD displays as shown in
Figure 3-1 or 3-2.
3-4
"Checking the Operation of
Keysight B2900 User's Guide, Edition 5