Table of Contents
Advertisement
CAUTION
•
Auto key
Starts a repeat (continuous) measurement. If a repeat measurement is in
progress, stops it.
The repeat measurement is performed with the DC bias output of the Source
value. And the measurement result is displayed on the Single view, Dual view,
or Roll view. The repeat measurement result is not stored in the buffer.
•
USB-A connector
Used to connect a USB memory. After disconnecting the USB memory, wait 10
seconds before connecting it again or new one.
Turning the instrument off while the USB memory is being accessed may damage
the device.
•
Function keys
Six function keys are available below the display. They are assigned to the
softkeys, Config, Function, Trigger, Result, File, Program, I/O, System, and
More. For details, see
•
Assist keys
Five assist keys are available to the right of the display. They are assigned to
several softkeys, such as Mode, Source, Limit, Measure, and More. The softkey
assignment depends on the display mode (Single, Graph, Roll, or Dual). For
details, see
Chapter 4, "Front Panel Reference."
•
View key
Changes the display mode. Pressing the key changes the mode as shown below.
On B2901A
On B2902A
On B2911A
On B2912A
•
Cancel / Local key
Cancels the setup operation if the instrument is in the local status. Returns the
instrument to the local status if it is in the remote status.
Keysight B2900 User's Guide, Edition 5
Chapter 4, "Front Panel Reference."
Single Graph (return to Single)
Dual Single for channel 1 Single for channel 2
Graph (return to Dual)
Single Graph Roll (return to Single)
Dual Single for channel 1 Single for channel 2
Graph Roll (return to Dual)
Introduction
Front View
2-5
Advertisement
Table of Contents
