Trigger Output - Keysight Technologies B2900 Series User Manual

Table 6-5
Trigger output timing
Starting ARM loop
Ending ARM loop
Starting TRIGGER loop
Ending TRIGGER loop
Starting Transient device action
Ending Transient device action
Starting Acquire device action
Ending Acquire device action

Trigger Output

B2900 can output trigger at the timing of Trigger output shown in
trigger output terminal can be selected from the following terminals.
• Internal bus, INT1, INT2
• LAN port
• Digital I/O pin, EXT1, EXT2, EXT3, EXT4, EXT5, EXT6, EXT7, EXT8,
EXT9, EXT10, EXT11, EXT12, EXT13, EXT14
The trigger output can be set by using
4-38. The trigger output timing and the setup parameters are shown in
Trigger Output Timing and Setup Parameters
For using a digital I/O pin, it is necessary to set function of the pin, output trigger
polarity, type, pulse width, and the Output Trigger Timing parameter. See
Configuration dialog box" on page 4-48
Keysight B2900 User's Guide, Edition 5
"Trigger Configuration dialog box" on page
Layer Action
ARM TRANS. for
transient
ARM
action or
ACQ. for
TRIGGER
acquire
TRIGGER action
ACTION TRANS.
ACTION TRANS.
ACTION ACQ.
ACTION ACQ.
and "Using Digital I/O" on page
Function Details
Trigger System
Figure 6-8. The
Table 6-5.
Output
Trigger
Trigger
Output
Timing
ON BEFORE
ON AFTER
ON BEFORE
ON AFTER
ON BEFORE
ON AFTER
ON BEFORE
ON AFTER
"DIO
3-34.
6-31