Pc With Wi-Fi Adapter - D-Link DPN-144DG User Manual

Gpon ont dual band wireless ac1200 voip gateway with 1 gpon port, 4 10/100/1000base-t ports, 2 fxs ports, and 1 usb port
Hide thumbs Also See for DPN-144DG:
Table of Contents

Advertisement

DPN-144DG GPON ONT Dual Band Wireless AC1200
VoIP Gateway with 1 GPON Port, 4 10/100/1000Base-T
Ports, 2 FXS Ports, and 1 USB Port
User Manual

PC with Wi-Fi Adapter

1. To connect via USB modem: connect your USB modem to the USB port
back panel of the gateway.
!
In some cases you will need to reboot the gateway after connection of the USB modem.
2. To connect the device to a fiber optic line: connect the fiber optic cable to the PON port on
the back panel of the gateway. Make sure that center conductor of the cable is inserted
directly into the center of the PON connector. Secure the cable by carefully pushing the fiber
connector onto the PON connector until tight. Be careful not to over-tighten the connector or
you may damage either the cable or the device.
3. To connect the device to an Ethernet line: in the web-based interface of the gateway, select
the gateway's LAN port that will be used as the WAN port and create an Ethernet WAN
connection. Then connect an Ethernet cable between an available Ethernet port of the
gateway and the Ethernet line.
!
Please connect the gateway to the ISP's Ethernet line only after setting the WAN port and
creating the Internet connection.
4. Connect the power cord to the power connector port on the back panel of the gateway, then
plug the power adapter into an electrical outlet or power strip.
5. Turn on the gateway by pressing the POWER ON/OFF button on its back panel.
6. Make sure that your Wi-Fi adapter is on. As a rule, modern notebooks with built-in wireless
NICs are equipped with a button or switch that turns on/off the wireless adapter (refer to
your PC documents). If your PC is equipped with a pluggable wireless NIC, install the
software provided with your Wi-Fi adapter.
Then make sure that your Wi-Fi adapter is configured to obtain an IP address automatically (as
DHCP client).
9 It is recommended to use a USB extension cable to connect a USB modem to the gateway.
Page 25 of 217
Installation and Connection
9
located on the

Advertisement

Table of Contents
loading

Table of Contents