Connecting To Web-Based Interface - D-Link DPN-144DG User Manual

DPN-144DG GPON ONT Dual Band Wireless AC1200
VoIP Gateway with 1 GPON Port, 4 10/100/1000Base-T
Ports, 2 FXS Ports, and 1 USB Port
User Manual

Connecting to Web-based Interface

When you have configured your computer, you can access the web-based interface and configure
needed parameters (create a WAN connection, change the parameters of the wireless network,
configure VoIP, specify the settings of the firewall, etc.).
For security reasons, DPN-144DG with default settings cannot connect to the Internet. To
!
get started, please set your own password used to access the web-based interface and, if
needed, configure other settings recommended by your ISP.
Start a web browser (see the Before You Begin section, page 17). In the address bar of the web
browser, enter the IP address of the gateway (by default, 192.168.0.1). Press the Enter key.
Figure 12. Connecting to the web-based interface of the DPN-144DG device.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the
gateway, make sure that you have properly connected the gateway to your computer.
If the device has not been configured previously or the default settings have been restored, after
access to the web-based interface the Initial Configuration page opens (see the Initial
Configuration section, page 36).
Figure 13. The Initial Configuration page.
Page 29 of 217
Installation and Connection