Pc With Wi-Fi Adapter - D-Link DPN-144DG Quick Installation Manual

DPN-144DG

PC with Wi-Fi Adapter

1. To connect via USB modem: connect your USB modem to the USB port
located on the back panel of the gateway.
!
In some cases you will need to reboot the gateway after connection of the
USB modem.
2. To connect the device to a fiber optic line: connect the fiber optic cable
to the PON port on the back panel of the gateway. Make sure that center
conductor of the cable is inserted directly into the center of the PON
connector. Secure the cable by carefully pushing the fiber connector onto
the PON connector until tight. Be careful not to over-tighten the
connector or you may damage either the cable or the device.
3. To connect the device to an Ethernet line: in the web-based interface of
the gateway, select the gateway's LAN port that will be used as the WAN
port and create an Ethernet WAN connection. Then connect an Ethernet
cable between an available Ethernet port of the gateway and the Ethernet
line.
!
Please connect the gateway to the ISP's Ethernet line only after setting
the WAN port and creating the Internet connection.
4. Connect the power cord to the power connector port on the back panel of
the gateway, then plug the power adapter into an electrical outlet or power
strip.
5. Turn on the gateway by pressing the POWER ON/OFF button on its
back panel.
6. Make sure that the Wi-Fi adapter of your PC is on. As a rule, modern
notebooks with built-in wireless NICs are equipped with a button or
switch that turns on/off the wireless adapter (refer to your PC documents).
If your PC is equipped with a pluggable wireless NIC, install the software
provided with your Wi-Fi adapter.
Then make sure that your Wi-Fi adapter is configured to obtain an IP address
automatically (as DHCP client).
3 It is recommended to use a USB extension cable to connect a USB modem to the
gateway.
Quick Installation Guide
3
9