Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
This product contains software
for use with Windows XP, 2000,
Me, and 98SE.
Before You Begin
You will need the following:
• Pentium III, 750MHz or above based computer with a CD-ROM Drive
and a minimum of 64MB RAM with Windows XP, 2000, Me, or 98SE.
• IEEE 802.11g wireless adapter with an IP address.
• Web browser with Javascript enabled. Internet Explorer 5.x or above,
Netscape 6.x or above, Mozilla 1.0 or above, or Opera 6.05 or above.
• Projector or Monitor with VGA connector and VGA cable.
Check Your Package Contents
These are the items included with your purchase:
If any of the below items are missing, please contact your reseller.
©2004 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of
their respective holders. Software and specifications subject to change without notice. DPG-2000W.03232004
DPG-2000W Wireless Presentation Gateway
Installation CD (Contains Software, Quick
Installation Guide, and Manual)
802.11g Antenna
AC Power Adapter
DPG-2000W
Wireless Presentation
Using a power supply
with a different voltage
rating will damage this
product and void the warranty.
Gateway
Advertisement
Table of Contents
Related Manuals for D-Link DPG-2000W
Summary of Contents for D-Link DPG-2000W
-
Page 1: Before You Begin
These are the items included with your purchase: If any of the below items are missing, please contact your reseller. ©2004 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of their respective holders. Software and specifications subject to change without notice. DPG-2000W.03232004... -
Page 2: Connections And Leds
Connections and LEDs Front Panel Wireless LED: During boot-up this LED will remain unlit. While waiting for a connection the LED blinks amber rapidly. A solid green light indicates a connection with a PC has been established. Power LED: Lights solid green when connected to a power source. - Page 3 Be sure the antenna is secure and in an upright position. Connect the DPG-2000W to a monitor or projector Connect a standard VGA monitor cable to the 15 pin connector labeled Projector/ Monitor on the rear panel.
- Page 4 Establishing a Wireless Link with the DPG-2000W When the DPG-2000W is connected to a monitor or projector and fully booted, a banner screen will appear. The SSID and channel information are displayed at the top of the screen. Wireless Utility Configuration...
- Page 5 If you wish to run the Presentation Session Manager directly from the CD- ROM, click on the Run from CD option and proceed to page 8. Insert the DPG-2000W CD in to the CD-ROM drive and the following screen will appear.
- Page 6 Installing the Presentation Session Manager (PSM) Software (continued) Click Next to use the default destination folder. Click Next to proceed with the Typical install.
- Page 7 Installing the Presentation Session Manager (PSM) Software (continued) Click Next to use the default program folder. Click Finish to complete the installation.
- Page 8 Before Starting the Presentation Session Manager, your system must have a valid IP address. If you installed the PSM software on your computer, Go to: Start > Programs > D-Link Air Plus G DPG-2000W Utility > DPG2000W to launch the PSM. Click...
- Page 9 Note: The PSM window must remain open but can be minimized. Click You should now be connected to the DPG-2000W. To install the administration software and for additional installation and troubleshooting information, please refer to the Technical Manual on the CD-ROM.
-
Page 10: Troubleshooting
Troubleshooting If you are unable to connect or establish a session with the DPG-2000W. • Verify the SSID of the wireless adapter matches the SSID of the DPG-2000W displayed on the banner page on boot up. • Ensure the computer’s wireless network adapter is set for Infrastructure mode. - Page 11 Notes...
- Page 12 You can find software updates and user documentation on the D-Link website. D-Link provides free technical support for customers within the United States and within Canada for the duration of the warranty period on this product. U.S. and Canadian customers can contact D-Link Technical Support through our website, or by phone.