Connecting To Pc - D-Link DPN-1021G User Manual

DPN-1021G GPON ONT VoIP Gateway with 1 GPON
Port, 1 10/100/1000Base-T Port, 1 10/100Base-TX Port,
and 1 FXS Port
User Manual

Connecting to PC

!
nvisible laser radiation may be emitted from the end of the fiber and/or from DPN-1021G .
I
Take all necessary precautions to avoid unnecessary exposure to this radiation.
1. Connect an Ethernet cable between the Ethernet port of your PC and the 10/100/1000Base-T
port (LAN1) or 10/100Base-TX port (LAN2).
2. To connect the device to a fiber optic line: connect the fiber optic cable to the PON port in
the bottom panel of the gateway. Make sure that center conductor of the cable is inserted
directly into the center of the PON connector. Secure the cable by carefully pushing the fiber
connector onto the PON connector until tight. Be careful not to over-tighten the connector or
you may damage either the cable or the device.
3. To connect the device to an Ethernet line: in the web-based interface of the gateway, select
the gateway's LAN port that will be used as the WAN port and create an Ethernet WAN
connection. Then connect an Ethernet cable between an available Ethernet port of the
gateway and the Ethernet line.
!
Please connect the gateway to the ISP's Ethernet line only after setting the WAN port and
creating the Internet connection.
4. Connect a phone cable between the FXS port of the gateway and the phone.
5. Connect the power cord to the power connector port on the back panel of the gateway, then
plug the power adapter into an electrical outlet or power strip.
6. Turn on the gateway by pressing the ON/OFF button on its back panel.
7. Wait for several minutes. When the device receives all needed settings, the GPON LED will
stop blinking and will light solid green. When the Internet connection is established, the
Internet LED will light solid green.
Page 14 of 145
Installation and Connection