Table of Contents
Advertisement
DPN-144DG GPON ONT Dual Band Wireless AC1200
VoIP Gateway with 1 GPON Port, 4 10/100/1000Base-T
Ports, 2 FXS Ports, and 1 USB Port
User Manual
Connecting to PC
!
Invisible laser radiation may be emitted from the end of the fiber and/or from DPN-144DG .
Take all necessary precautions to avoid unnecessary exposure to this radiation.
PC with Ethernet Adapter
1. Connect an Ethernet cable between any of LAN ports located on the back panel of the
gateway and the Ethernet port of your PC.
2. To connect via USB modem: connect your USB modem to the USB port
back panel of the gateway.
!
In some cases you will need to reboot the gateway after connection of the USB modem.
3. To connect the device to a fiber optic line: connect the fiber optic cable to the PON port on
the back panel of the gateway. Make sure that center conductor of the cable is inserted
directly into the center of the PON connector. Secure the cable by carefully pushing the fiber
connector onto the PON connector until tight. Be careful not to over-tighten the connector or
you may damage either the cable or the device.
4. To connect the device to an Ethernet line: in the web-based interface of the gateway, select
the gateway's LAN port that will be used as the WAN port and create an Ethernet WAN
connection. Then connect an Ethernet cable between an available Ethernet port of the
gateway and the Ethernet line.
!
Please connect the gateway to the ISP's Ethernet line only after setting the WAN port and
creating the Internet connection.
5. Connect a phone cable between an FXS port of the gateway and the phone.
6. Connect the power cord to the power connector port on the back panel of the gateway, then
plug the power adapter into an electrical outlet or power strip.
7. Turn on the gateway by pressing the POWER ON/OFF button on its back panel.
8. Wait for several minutes. When the device receives all needed settings, the PON LED will
stop blinking and will light solid green. When the Internet connection is established, the
Internet LED will light solid green.
Then make sure that your PC is configured to obtain an IP address automatically (as DHCP client).
8 It is recommended to use a USB extension cable to connect a USB modem to the gateway.
Page 19 of 217
Installation and Connection
8
located on the
Advertisement
Table of Contents
