Table of Contents
Advertisement
DPN-144DG GPON ONT Dual Band Wireless AC1200
VoIP Gateway with 1 GPON Port, 4 10/100/1000Base-T
Ports, 2 FXS Ports, and 1 USB Port
User Manual
Parameter
BG protection
Short GI
Drop multicast
Beacon period
RTS threshold
Frag threshold
DTIM period
Station Keep Alive
When you have configured the parameters, click the APPLY button.
Available on the 2.4GHz tab.
The 802.11b and 802.11g protection function is used to minimize
collisions between devices of your wireless network.
Select a value from the drop-down list.
Auto: The protection function is enabled and disabled automatically
depending on the state of the network (this value is recommended if
your wireless local area network consists of both 802.11b and
802.11g devices).
Always On: The protection function is always enabled (this setting
can substantially lower the efficiency of your wireless network).
Always Off: The protection function is always disabled.
Guard interval (in nanoseconds). This parameter defines the interval
between symbols transmitted when the gateway is communicating to
wireless devices.
Enable: the gateway uses the 400 ns short guard interval. Only for
the wireless network operating modes which support 802.11n and
802.11ac standards (see the value of the Wireless mode drop-
down list on the Wi-Fi / Basic Settings page).
Disable: the gateway uses the 800 ns standard guard interval.
Move the switch to the right to disable multicasting for the gateway's
WLAN. Move the switch to the left to enable multicasting from the
WAN connection selected in the IGMP section on the
Connections Setup / WAN page.
The time interval (in milliseconds) between packets sent to
synchronize the wireless network.
The minimum size (in bytes) of a packet for which an RTS frame is
transmitted.
The maximum size (in bytes) of a non-fragmented packet. Larger
packets are fragmented (divided).
The time period (in seconds) between sending a DTIM (a message
notifying on broadcast or multicast transmission) and data
transmission.
The time interval (in seconds) between keep alive checks of wireless
devices from your WLAN. When the value 0 is specified, the
checking is disabled.
Page 109 of 217
Configuring via Web-based Interface
Description
Advertisement
Table of Contents
