Connections Setup; Wan - D-Link DPN-144DG User Manual

Gpon ont dual band wireless ac1200 voip gateway with 1 gpon port, 4 10/100/1000base-t ports, 2 fxs ports, and 1 usb port
Hide thumbs Also See for DPN-144DG:
Table of Contents

Advertisement

DPN-144DG GPON ONT Dual Band Wireless AC1200
VoIP Gateway with 1 GPON Port, 4 10/100/1000Base-T
Ports, 2 FXS Ports, and 1 USB Port
User Manual

Connections Setup

In this menu you can configure basic parameters of the gateway's local area network and configure
connection to the Internet (a WAN connection).

WAN

When the gateway connects to a fiber optic line, a WAN connection is created and
configured automatically.
!
When the gateway connects to an Ethernet line or a mobile network, you should configure
your Ethernet WAN connection in accordance with data provided by your Internet service
provider (ISP). Make sure that you have obtained all necessary information prior to
configuring your connection. Otherwise contact your ISP.
On the Connections Setup / WAN page, you can create and edit connections used by the
gateway.
To create a new connection, click the Add button in the Connections List section. On the opened
page, specify relevant parameters.
To edit an existing connection, in the Connections List section, left-click the relevant line in the
table. On the opened page, change the parameters and click the APPLY button.
To disconnect a connection and establish it again, select the checkbox located to the left of the
relevant line in the table and click the Reconnect button.
On the Basic tab, mandatory settings of a WAN connection are displayed. To view all available
settings of the needed WAN connection, go to the All Settings tab.
To remove a connection, in the Connections List section, select the checkbox located to the left
of the relevant line in the table and click the Delete button. Also you can remove a connection on
the editing page.
To allow multicast traffic (e.g. streaming video) for a connection, in the IGMP section, select the
choice of the radio button which corresponds to this connection (only for connections of the
Dynamic IPv4 or Static IPv4 type).
Figure 33. The Connections Setup / WAN page.
Page 48 of 217
Configuring via Web-based Interface

Advertisement

Table of Contents
loading

Table of Contents