Pneumatic Connection 1 And 2 (Thread Size G½ Or Npt½−14); Pneumatic Connection 3 (Thread Size G1 Or Npt1) - Festo MS6-SV Operating Instructions Manual

MS6(N)−SV
Pneumatic connection 1 and 2 (thread size G½ or NPT½−14)
If using screw connectors with width across flats larger than SW24:
Remove the MS6−END cover cap, if fitted (push upwards).
S
If using screw connectors:
Note the maximum permitted screw−in depth of the connector threads:
S
Max. screw−in depth [mm]
ISO 228
10.0
For larger screw−in depths, it is necessary to use MS6−AG.../AQ... sub−bases
from Festo.
Make sure that the compressed air tubing is connected correctly.
S
Screw the connectors into the pneumatic ports using suitable sealing material.
S

Pneumatic connection 3 (thread size G1 or NPT1)

Exhausting a system using the MS6(N)−SV results in high levels of noise. We
therefore recommend that you use a silencer.
Warning
If a commercially−available silencer is used, the body of the silencer may
become clogged, which can result in reduced exhaust performance
(back pressure).
S Use the safety silencer designed for the device (è chapter 12 Accessories").
S Only use a commercially−available silencer if it will be maintained at regular
intervals by service staff and if also using a back pressure monitoring system.
Screw the silencer into pneumatic port 3. For MS6N−SV, an adapter must also
S
be mounted between silencer and device.
Make sure that there is unrestricted exhausting. Neither the silencer nor port 3
S
should be blocked.
42
NPT
10.0
Festo MS6(N)−SV 0904a English