Festo MS6-SV Operating Instructions Manual page 41

MS6(N)−SV
Combination with service units of the MS series
Warning
Incorrectly installing the device in the service unit combination can impair the
MS6(N)−SV's safety function.
S Only devices that do not impede the MS6(N)−SV's pneumatic safety measure
(safe exhausting) may be placed after the MS6(N)−SV.
If fitted together with one or several existing service units of the same series
(è Fig. 4):
1. Remove the MS6−END cover cap ( 1 ), if fitted, from the side to be combined
(push upwards).
2. Place the MS6−MV module connectors ( 2 ) in the grooves of the individual
units. There must be a seal between the individual units.
3. Fasten the MS6−MV module connectors with two screws.
1
MS6−END cover cap
Fig. 4
Festo MS6(N)−SV 0904a English
1
2
max 1.2 Nm
2
MS6−MV module connector
41