Configure Hpe Synergy Image Streamer - HPE Synergy 12000 Frame Setup And Installation Manual

Hide thumbs Also See for Synergy 12000 Frame:

Table of Contents

Wait for HPE OneView to complete the add operation.

b. Confirm that the inventory includes all installed components.

c. For any hardware not discovered by HPE OneView, look for problems with frame link module

cabling, hardware not fully inserted, or other hardware issues.

4. Review and correct any issues listed in the Hardware Setup Checklist.

a. To troubleshoot all issues, follow corrective actions in HPE OneView.

b. Return to the Hardware Setup screen and check for additional issues until the Checklist indicates

Setup complete.

For more information about using HPE OneView, see the online help by clicking the question mark on

the top bar of the Synergy console.

5. (Optional) Select Edit networking from the Hardware Setup screen.

Edit the HPE OneView networking settings and click OK. The Maintenance IP address fields are

required unless you have disabled service console access.

6. To add a remote enclosure, select Actions > Add remote enclosures from the Hardware Setup

screen.

Enter the IPv6 address of a frame link module that is connected to a frame in the remote frame link

topology. The remote frame link topology must be in the same subnet as the primary frame link

topology.

7. Unmanaged interconnect modules require console access for initial setup. Click the Actions menu on

the top bar of the Synergy console and select the module from the Serial Consoles > Interconnects

menu. Press the Enter key to begin the serial console session with that interconnect module.

Configure the interconnect module using the instructions provided with the module. To close the

session, click the X in the top right corner.

NOTE: To access the serial console for an interconnect module, connect to the Synergy console

through ports in the same frame as the module. For more information, see the procedures for

connecting to the Synergy console.

8. Log out from the HPE OneView Hardware Setup session.

To close the session, click the X in the top right corner of the Synergy console.

After hardware setup is complete, the system is ready to be configured for a production environment.

An HPE OneView administrator can perform configuration tasks with an account that provides

additional user privileges.

For more information about HPE OneView administration, see the HPE OneView online help or the

HPE OneView User Guide for Synergy.

For operating system deployment options on HPE Synergy, see the HPE Synergy 12000 Frame Setup

and Installation Guide.