Configuring Hpe Oneview To Deploy Os Build Artifacts To Compute Modules - HPE Synergy 12000 Frame Setup And Installation Manual

Procedure
1. Create a management network that is consistent with the HPE OneView management network.
2. Add an IPv4 subnet and address range.
Define the range of IPv4 addresses and subnets to set aside for each Image Streamer appliance in
the frame link topology, plus the number of operating system servers expected to be deployed.
3. Add an OS deployment server for use in HPE OneView to deploy operating systems to managed
servers.
4. Create a deployment network to enable operating system deployment to servers using Image
Streamer.
5. Create one or more logical interconnect groups to define the connections between Image Streamer
appliances and the servers they will support.
6. Create an enclosure group that includes the Image Streamer configuration.
7. Create a logical enclosure to define the set of frames to which to apply the Image Streamer enclosure
group.
For more information about configuring HPE Image Streamer, see the HPE OneView online help or the
HPE OneView User Guide on the Hewlett Packard Enterprise website (http://www.hpe.com/info/
synergy-docs).

Configuring HPE OneView to deploy OS build artifacts to compute modules

Once you add an Image Streamer OS deployment server in HPE OneView, you can launch the Image
Streamer graphical user interface from the HPE OneView OS Deployment Servers screen.
Procedure
1. Upload artifacts from a bundle or create new artifacts.
From the Image Streamer interface, the software administrator can upload artifacts from a bundle for
use in HPE OneView or use the Image Streamer interface to create golden images and other OS build
artifacts.
2. Create or configure a server profile.
Create and apply a server profile which includes an OS deployment selection and values for the
server-specific settings for the selected OS deployment.
3. Verify operating system deployment.
Review server profile screen details to view the operating system volume that has been created as a
result of deployment.
4. Power on the compute module.
Power on server to boot from deployed operating system.
For more information about using Image Streamer to create and deploy OS build artifacts, see the Image
Streamer online help or the HPE Image Streamer User Guide on the Hewlett Packard Enterprise website
(http://www.hpe.com/info/synergy-docs).
78 Configuring HPE OneView to deploy OS build artifacts to compute modules