Labnet Excel E10-1 Operation Manual page 29

5. Press «SET» to confirm the selection.
6. Under symbol, "01" will appear. Press
the volume of the first dispense.
7. Press «SET» to confirm the selection.
8. Repeat steps 6 and 7 to set the sequential dispensing volumes. The total
dispensing volume cannot exceed the maximum volume range.
9. Press «SET» to confirm the selection.
10. The count "01" and the total aspirating volume will appear on the
display. The pipetting direction and speed
LABNET Excel electronic pipettor is ready for liquid pick-up. Press the
button to aspirate the sample. When the aspiration is
PLUNGER
completed, the dispensing count and volume will appear and
flash to indicate that the LABNET Excel electronic pipettor is ready for
dispensing.
11. The LABNET Excel electronic pipettor will make two beeping sounds
to remind the user of the last measured volume to dispense. At the
end of the sequential dispensing cycle, if Reverse Pipette mode is
selected, will be displayed to remind the user to press
button to the dispense the remaining extra amount of sample. After
completing the dispensing, pressing the
re-activate the whole cycle until the user changes the function mode.
Note: If the blow-out setting is selected, the LABNET Excel electronic
pipettor will automatically blow-out the liquid at the end of a sequential
dispensing cycle.
«Up/Down» to set
will flash to indicate the
button again will
PLUNGER
25
will
PLUNGER