Subscribe to Our Youtube Channel
Related Manuals for Labnet Enduro MiniMix
Summary of Contents for Labnet Enduro MiniMix
- Page 1 Labnet Enduro MiniMix ™ Nutating Mixer Instruction Manual Catalog Numbers: S0600 S0600-230V S0600-230V-UK...
- Page 2 Table of Contents 1.0 Introduction ................. . .1 2.0 Symbols and Conventions .
- Page 3 The Enduro MiniMix achieves its 3-dimensional mixing by combining the rotating motion of an orbital shaker with the rocking motion of a platform rocker. The modern styling of the Enduro MiniMix’s housing is achieved through the use of injection molded FRABS plastic.
- Page 4 4.0 Installation The Labnet Enduro™ MiniMix can be used on a bench, in a cold room or in an incubator up to 40°C. Place the unit on a flat stable surface and be sure to leave sufficient room around the unit to allow both the platform and load to move freely. A minimum of 4 inches (10 cm) clearance on all sides of the mixer is advised.
- Page 5 9.0 Equipment Disposal According to Directive 2012/19/EU of the European Parliament and of the Council of 4 July 2012 on waste electrical and electronic equipment (WEEE), this product is marked with the crossed-out wheeled bin and must not be disposed of with domestic waste.
- Page 6 To request certificates, please contact us at www.labnetlink.com. Warranty/Disclaimer: Unless otherwise specified, all products are for research use or general laboratory use only.* Not intended for use in diagnostic or therapeutic procedures. Not for use in humans. These products are not intended to mitigate the presence of microorganisms on surfaces or in the environment, where such organisms can be deleterious to humans or the environment.
Need help?
Do you have a question about the Enduro MiniMix and is the answer not in the manual?
Questions and answers