Mira event Installation, Operation, Maintenance Manual page 37

Pump
assembly
Inlet
manifold
Torsion spring
Cover
retaining
screw
Indicator trim
'O' seals
Mixer
assembly
Actuator
Temperature
knob
Flow knob
37
6.4. Separate the mixer assembly
from the inlet manifold and the
pump assembly.
6.5. Refit in reverse order.
Note! Ensure actuator and
torsion spring are correctly
fitted. Refer to "PCB and
Micro-switch Renewal".
Note! Ensure that the 'O'
seals between the mixer
assembly and the pump
assembly are correctly
seated on each male spigot.
Tip! When refitting the
mixer assembly lightly
grease 'O' seals with a
silicone based lubricant.
6.6. Restore the water supplies
and check for any leaks.
6.7. Refit the cover by locating
the cover onto the tongue on
the top of the case. Push the
bottom of the cover against
the case, tighten the cover
retaining screw, refit the
temperature knob,
temperature trim and flow
knob.