Mira event Installation, Operation, Maintenance Manual page 24

For a Hotter shower temperature
2.5. For a Hotter shower
temperature, use the push-fit
release tool to lever off the
temperature knob and rotate
the temperature knob
clockwise so that the lever is
in the 4 o'clock position and
refit. Turn lever anti-
clockwise and check that the
new maximum temperature
setting is correct. Repeat
procedure if maximum
temperature is not hot
enough.
For a Cooler shower temperature
2.6. For a Cooler shower
temperature, turn the
temperature lever clockwise
until the required temperature
has been achieved. Use the
push-fit release tool to lever
off the temperature knob and
rotate the temperature knob
anti-clockwise until the end of
the slot in the temperature
knob is against the left hand
stop of the cover insert. Refit
the temperature knob.
2.7. Refit the indicator trim and
flow knob taking care to
correctly engage the key-
ways.
2.8. Turn the flow control fully off.
2.9. Recheck maximum
temperature setting.
For a hotter
shower
temperature
For a cooler shower
temperature
Left hand stop
Temperature
knob
24
Cover insert
Indicator
trim
Flow knob