Mira event Installation, Operation, Maintenance Manual page 20

1.10. Push the supply pipework
inside the inlet manifold
until resistance is felt.
DO NOT FORCE!
Warning!
Do not insert fingers into
the push-fit connectors as
this can result in injury.
1.11. The collet and 'O' seal will
automatically make a
hydraulic seal.
Important!
This Mira Event must be
fixed to the wall at all three
fixing positions.
The fixing holes are
elongated to assist in
vertical and horizontal
alignment.
1.12. Screw the Mira Event to the
wall using either the
supplied wall screws or
alternative fixings
depending on the wall
structure.
Do not over tighten!
Ensure that the electrical
supply cable is correctly
seated in the channel in the
back of the case.
1.13. Connect the conductors of
the electrical supply cable
to the terminal block.
Take the earth wire to the
earth stud adjacent to the
PCB terminal block. The
supply cable earth
connector should be
sleeved.
20