Specifications - Mira event Installation, Operation, Maintenance Manual

Section
4
1. General
1.1. Continuous duty cycle - 15 minutes on, 60 minutes off.
1.2. The motor is fitted with self-resetting thermal trip protection, designed to
operate if the duty cycle is exceeded or ambient temperatures become
too high.
1.3. Ambient temperature - Maximum recommended ambient temperature
for the appliance is 30°C.
1.4. Hot Water Temperature - Maximum temperature 80°C.
BS 6700 recommends that the temperature of stored water should never
exceed 65°C. A stored water temperature of 60°C is considered sufficient
to meet all normal requirements and will minimise the deposition of scale
in hard water areas.
1.5. Maximum static inlet pressures - 1 bar or 10m (supplies must be
gravity-fed at nominally equal pressures). Refer to "Installation
Requirements – Plumbing; Note 3.18" for futher advice.
1.6. Minimum static inlet pressure - 0.0075 bar or 75mm (required to prime
the integral centrifugal pump).
1.7. Maximum recommended inlet pressure - 0.5 bar or 5m (supplies must
be gravity-fed at nominally equal pressures).
1.8. Noise - The powerful pump motor is fitted on rubber isolation mounts to
reduce the transmitted sound levels. The type of wall surface will affect
the perceived sound levels. Solid walls will provide a quieter operation.
2. Plumbing
2.1. Inlet - 15mm Push-fit inlet manifold
2.2. Outlet -
3. Electrical
3.1. Appliance power supply - 230/240 V, 50Hz, fused at 3 Amps, via a
double pole switched fused connection unit (not supplied) with a minimum
3mm contact separation in each pole.
3.2. Power supply connection - The Event is fitted with a terminal block and
earth stud which will accept cable up to 2.5mm².
3.3. Absorbed power - Approximately 150 Watts under normal working
conditions.

Specifications

" BSP to BS2779.
1
/
2
8