Mira event Installation, Operation, Maintenance Manual page 19

Chamfer
1.9. Ensure that the end of the
supply pipework is cut
squarely and free from burrs,
which will damage the inlet
manifold seals.
Chamfer the end of the pipe to
assist insertion into the fitting
and prevent tearing the 'O'
seal.
Thoroughly flush the
incoming hot and cold water
supply pipes (Bye-law 55).
Note! If using chrome plated
copper pipework then all
traces of chrome plate will
need to be removed from the
connecting surfaces. If the
chrome is not completely
removed then the inlet
manifold collet will not grip the
supply pipe and under
pressure the pipes may be
forced out.
Do not use stainless steel
piping.
Note! PTFE tape or liquid
jointing is not required to
assist connection.
19