Before You Start - Mira event Installation, Operation, Maintenance Manual

5. Before You Start

The Mira Event features a 15mm dual entry push-fit inlet manifold to enable the
appliance to support three inlet supply configurations. Choose the appropriate
inlet supply configuration to suit your installation before proceeding to install the
appliance.
The inlet manifold is factory fitted with inlet two blanking plugs fitted to the top
inlets and allows for a bottom inlet supply configuration. The blanking plugs can
be repositioned to suit the installation's supply pipework configuration. A push-fit
release tool is provided which can be used to lever out the blanking plugs. Refer
to "Change the Inlet Supply Ports" for the complete procedure.
The Event will accept three dual inlet supply configurations:-
Top inlet supply
Bottom inlet supply – Seal off top inlets of manifold.
Back inlet supply
To enhance the final appearance of the appliance the Mira Event case features
two removable inlet blanking plates which are factory fitted in to the top and
bottom of the case.
These blanks can be removed as follows to allow the three inlet supply
configurations:-
Top inlet supply
Bottom inlet supply – Remove bottom inlet blanking plate.
Back inlet supply
required.
The Mira Event case also
caters for top, bottom or back
electrical supply cable entry.
In the case of top or bottom
entry this is achieved by
cutting away and trimming
thinned sections in the top
and bottom of the case. The
cable can then be fitted into a
moulded channel running up
and down the back of the
case.
– Seal off bottom inlets of manifold.
– Seal off bottom inlets of manifold.
– Remove top inlet blanking plate.
– Removal of top or bottom inlet blanking plates not
Moulded channel
for electrical
supply cable
Top inlet supply
Inlet blanking plate
Bottom inlet supply
14
Back
inlet
supply